Jiangsu Qiangcheng Machinery Manufacturing Co., Ltd.
News
-
What is the working principle of the hydraulic cutting machine?
Transmission of hydraulic cutting machine: it is the hydraulic oil as the working medium, through the power element (oil pump) the mechanical energy of motivation into hydraulic oil, and then through the control element, then with the execution element (oil cylinder or oil motor) will convert the...Read more -
Solution for high oil temperature in hydraulic cutting press machine system
Solution for high oil temperature in hydraulic cutting machine system: 1. Cut the oil in the oil tank is insufficient. Refuel and increase the oil tank; 2. Set the pressure too high and adjust the pressure appropriately; 3. The components of the unloading circuit, such as the relief valve, unload...Read more -
Cutting machine manufacturer–cutting press machine’s current status processing principle
Status of cutting machine usage: 1. The mechanical transmission cutting machine, although there are still manufacturers to continue production, some small, individual manufacturers are still using, but this form of cutting machine is bound to be eliminated. 2. Hydraulic-powered cutting machines r...Read more -
What are the requirements for operating a cutting press machine
In some light industries, cutting and dividing items will inevitably use cutting machines. In modern times, with the continuous change of cutting machines, ultrasonic technology and other technologies have been used in leather punching technology. So what are the rules when operating cutting mach...Read more -
Installation and troubleshooting of hydraulic control system for hydraulic cutting press machine
(1) Pay attention to the following points during installation and troubleshooting: a) Verify that the servo valve model in the hydraulic control system of the hydraulic cutting machine meets design specifications, confirm the dynamic and static performance of the factory-installed servo valve, an...Read more -
Briefly describe the composition and control method of hydraulic cutting press machine
The hydraulic cutting machine is composed of the following three basic parts. 1. Mechanical part: composed of the body, working mechanism and travel adjustment device, gantry hydraulic cutting machine also includes saddle moving feed device and automatic feeding device. 2. Hydraulic system: compo...Read more -
A brief analysis of how to judge the quality of hydraulic oil in cutting press machine
Hydraulic oil is the foundation of its work, hydraulic oil quality, not only affects the normal work of hydraulic cylinder, but also cause serious damage to hydraulic system parts, causing unnecessary trouble for workers. So, how to judge the quality of hydraulic oil in the cutting machine? 1. Vi...Read more -
Knowledge of cutting press machine maintenance
Before daily operation, thoroughly clean the cutting machine. The longer it remains unused, the harder it becomes to maintain. Check for loose screws and ensure proper tightening. The hydraulic oil in the tank should be replaced approximately every 2,400 hours of use, with new machines ideally re...Read more -
How to deal with common faults in the maintenance of cutting press machine?
1. The indicator light does not light up after the hydraulic cutting machine is started and the whole machine has no power: fault analysis ： 1. The transformer fuse is burned out; 2. The brake switch is not on. Cutting machine maintenance treatment method: 1. Replace the fuse; 2. Turn on the pow...Read more -
The cutting press machine achieves a new hydraulic volume throttling speed control circuit by changing the motor speed
The hydraulic cutting machine employs a variable frequency-driven volumetric throttling speed control circuit. The throttle valve regulates the flow rate entering the working mechanism. To regulate the oil pump’s output flow, a pressure detection transmitter is installed at the throttle val...Read more -
Basic knowledge of hydraulic cylinder for hydraulic cutting machine
With the advancement of modern industry, hydraulic transmission technology has been extensively applied and developed across numerous global industries. These include construction machinery such as loaders, bulldozers, and rollers; lifting equipment like forklifts, belt conveyors, and truck-mount...Read more -
The indicator light is not on after the hydraulic cutting machine is started
How to deal with the cutting machine before and after the failure Simple fault and maintenance of the cutting machine 1) Ask the equipment operator to perform the equipment. These include: whether the hydraulic system works normally; whether the hydraulic pump of the hydraulic cutting machine is ...Read more